DOME CAMERA WITH BUILT-IN WIDE DYNAMIC RANGE
S32 IP v3 delivers Wide Dynamic Range (WDR ) imagery to provide outstanding video in fluctuating light conditions. While traditional cameras can struggle with whiteout and black crush, the S32 IP v3 with WDR, automatically adjust exposure levels so that details that were previously not visible are easily observed. A full-metal vandal-resistant design protects the lens and circuitry for long-lasting performance.
Its unique 3D gimbal allows the base of the camera to be mounted in any orientation such as curved bus ceilings allowing the camera to be adjusted so the image is correctly oriented. Unlike conventional camera designs, the S32 IP v3 provides outstanding mounting flexibility.
CAMERA – HOUSING FEATURES:
INTEGRATED MICROPHONE
The Gatekeeper S – Series camera housing includes an integrated microphone allowing high quality audio to be captured at each camera.
INTEGRATED IR
The integrated IR utilizes 12 infrared LED’s to provide IR illumination at night. A sensor in the camera detects the ambient light and automatically turns on/off the IR LED’s as needed.
3D GIMBAL
The housing inherently implements a 3D gimbal design found in more expensive cameras. This allows the base to be mounted in almost any orientation while allowing the camera to be adjusted so that the image is correctly oriented.
TAMPER PROOF ADJUSTMENTS
Not only is the camera constructed of metal but there are set screws that when tightened, prevents the camera aim from being tampered with. This is important for installation where the camera can be accessed, either due to low ceilings or accessible camera placement.
ALL METAL HOUSING
An all-metal housing creates a vandal-proof package that is resistant to physical damage.
90 DEGREE PLUS AIMING
The housing profile has been carefully designed so that the camera can be aimed slightly more than 90° laterally and have a clear field of view. This is important for correct aiming when the camera is located at the front of a long vehicle.
TOLERANT TO INSTALLATION ERROR
The S32 IP v3 housing has been designed so that the camera ball cannot be positioned behind the camera’s shroud thus reflecting infrared light back into the lens. This reduces the probability of installation errors.
SEALED DESIGN
The ball that houses the camera electronics has no vents thus making the camera resistant to water spray.
VIBRATION DAMPING
In order to help reduce camera vibration, a rubber mounting ring is supplied. The rubber ring is installed between the camera base and the mounting surface. The rubber ring conforms to the camera base for easy alignment and quick installation.
FLEXIBLE CABLE ROUTING AND MOUNTING OPTIONS
The S32 IP v3 camera is secured with 4 screws that are not accessible once the installation is complete. The camera’s signal cable can be routed directly up through the camera base so that it’s not exposed. Alternatively, there are 4 cutouts in the base that allows the camera’s signal cable to be routed out the side of the base. This is useful when the camera is mounted to a surface that is not accessible from the rear.
INTERNAL IR LIGHT LEAKAGE ELIMINATED
On the front of the S32 IP v3 camera is a flat lens that protects the camera lens from the environment. This flat lens is divided into two concentric circles. The outside circle allows the IR light to exit the camera. The inner circle allows the camera’s imaging element to view the scene. A cylindrical sleeve is attached to the flat lens and delineates the outside and inside the circle. This cylinder extends from the flat lens and surrounds the camera lens. This mechanical assembly eliminates internally reflected IR light. Some camera designs have no such mechanism, while other designs use a soft rubber boot that is intended to prevent internal reflected IR from entering the camera lens. In Gatekeeper’s experience, a rubber boot can allow IR light to enter the lens and cause an optical flare. This can be exasperated as shorter lens sizes are used. The cylinder shroud used in Gatekeeper’s S32 IP v3 camera protects from internal reflected IR’s still maintained when shorter lenses are implemented.